Audio-Technica AT-VM95E Elliptical Phono Cartridge

• Genuine Audio-Technica AT-VM95E dual moving magnet cartridge
• Supplied with green AT-VMN95E bonded elliptical stylus, 0.3 × 0.7 mil
• Standard half-inch cartridge mounting; cartridge mass 6.1 g
• Tracking force: 1.8–2.2 g; manufacturer standard 2.0 g
• Output: 4.0 mV; frequency response 20–22,000 Hz
• Recommended load: 47 kΩ and 100–200 pF
• Headshell is not included

Manufacturer-listed mounting accessories: two 11 mm screws, two 8 mm screws and two washers. Replacement stylus reference: AT-VMN95E. The AT-VM95E is distinct from the older AT95E/ATN95E and from P-mount cartridges.

Audio-Technica documents AT-VM95E cartridges on the models below. Some use the black version from the factory; the individual guide identifies this difference. This offer supplies the green elliptical cartridge. Retain the correct headshell and follow model-specific alignment, balance and tracking-force instructions.

• AT-LP120XUSB
• AT-LP120XBT-USB
• AT-LPW40WN
• AT-LPW50PB
• AT-LPW50BT-RW
• AT-LP5X
• AT-LP7X

If only your existing VM95 stylus is worn, a replacement stylus may be all you need; this item is the complete cartridge and stylus assembly.

Fit the cartridge using the turntable manufacturer’s instructions and suitable alignment tools. Balance the tonearm and set the specified tracking force and anti-skate. A similar cartridge appearance or matching socket alone does not establish compatibility. The manufacturer image shows the product; no headshell is included.